BLDC controller 12 kW
Technical data
| Maximum power | 12 kW |
|---|---|
| Supply voltage | 18–90 V |
| Maximum current to the motor for 20s | 200 A |
| Maximum current draw for 20s | 180 A |
| Maximum continuous current draw | 100 A |
- Length
- 18 cm
- Width
- 9.5 cm
- Height
- 5 cm
- Weight
- 900 g
Price€470gross
- Warranty
- Invoice
In the boxController, cable with potentiometer, resistor, user manual
Give the code when ordering POWER, and you'll get a 5% discount on your order.
Description
Applications
With this device you can smoothly control the speed of a boat, motorcycle, go-kart or other vehicle.
Speed control
Electronic speed controller for brushless BLDC motors, used to control the motor speed.
- Connect the controller according to the drawing.
- Connect the yellow, green and blue wires to the motor.
- Make the connections with cable of at least 20mm2.
- Connect the supply minus to the black wire.
- Connect the supply plus to the red wire.
- Connect the thin red wire to the switch.
- Connect the switch to the red power wire.
- Before switching the controller on, set the potentiometer to zero (start of the range).
- The switch turns the motor on at any moment of operation.
- A 200A fuse should also be connected to the power supply.
- After longer continuous operation, check how hot the controller housing and the wire terminals get.
- If the wire terminals or the housing are too hot to hold in your hand, fit a fan for cooling.
The leads connecting the controller to the motor should be as short as possible. They are best joined by soldering, with heat-shrink tubing put over the soldered joint.
Ask about BLDC controller 12 kW